Question Locked

I have 2 existing EIDE HD's. I just bought a SATA HD. Can SATA HD be used..

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have 2 existing EIDE HD's. I just bought a SATA HD. How do I use the new SATA HD as my master boot HD and the old EIDE HDs as my storage drives? I've already copied everything from my master EIDE HD to the new SATA HD and everything is plugged in. When I boot up the system, it is still booting from the old EIDE HD and the new SATA HD is being used as storage in drive G:. Is there something else that I need to change in BIOS or do I have to configure the jumpers differently? Please help! My current OS is XP and the motherboard is a Soyo Dragon Plus 2 (sy-p4i865pe). TIA

10 replies

by hal 9000

As one of the IDE Drives is the Default Boot drive you need to copy the necessary files to it to allow the computer to be pointed to the SATA Drive to boot from.

Col

by jus2sho

Why does the OS have to be installed again onto the new SATA HD when it was cloned directly from the existing boot HD? Shouldn't the new HD take the same properties as the previous HD? Thanks again for your help.

by hal 9000

You placed a pointer on the Boot Drive to the position of the OS. Now that you want that OS to be in a different position you need to change the pointer to the SATA Drive and install the SATA Drivers if required in the initial setup of the system.
If you disconnect every IDE Drive the OS will still not boot off the SATA Drive will it? That is because the correct drivers and other necessary items are no longer present but you can get by with a repair install by following the directions here.

http://tinyurl.com/g4bv8

Col

by dumphrey

did clone the drive with ghost or such, you may just need to go in and manually edit the boot menu either through the repair console or System Properties. Even though you cloned the disk, all startup info still points to the default eide disk.

by jus2sho

When I go to disconnect all the IDE drives I also change BIOS to only read from the SATA ports and everything works fine. When the SATA and IDE ports are enabled with only the storage IDE HD connected to the primary plug, the system does not load up.

by hal 9000

Becomes the Default drive and needs the files to point the computer to the Windows Boot Files.

As you can remove the IDE Drives and have the system boot you must have a NVidia Chip Set M'Board right?

Col

by hal 9000

I've never seen a Intel 865 Chip Set M'Board that didn't need SATA Drivers to work. Anyway as you can install the SATA Drive and have it work or the IDE Drive and have it boot off that but you can not have both if you remove the Windows Folder from the Primary IDE Drive the computer will stop booting as it lacks the necessary Road Map to point the computer to the correct location for the Windows Files to boot from.

Wipe the IDE Drive and then run a Repair/In Place Install and you'll be working without a problem though you will most likely need the SATA Drivers copied to the Root of a Floppy when you perform the initial install.

Col

by stevethewirepuller

I had two IDE's and also just added a SATA to the same MOBO.

It did boot to the old IDE master. But I didn't try to get around that, I simply put the drive in an external USB enclosure after copying everything I urgently wanted to the SATA.

I would imagine you would just go into Tools and get rid of the boot partition. This would also delete any data of course.

This discussion is closed to new replies.