Discussion Locked

I need basic help networking 2 computers

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I got mysef into somethign I thought I could do but managed to get lost! I have an HP Pavilion 8570C and an PB Axcel 2420. I installed a network card on both of them. I am using a crossover cable to connect the two and I am getting a link light on both of them! Now my problem is I can not figure out where to go to map the network on each computer (I know, basic stuff for you guuys probably!) The PB has Win 95 and the HP has 98 which may help anyone who responds. I really hope someone can help because this is really important to my business. Thanks

8 replies

by cfburgess

The basic steps are to verify a like protocol on each machine, enable file and print sharing and then share the respective resources on the machines.
Under network properties on each machine look for the NetBeui protocol, if not present then install it. Also, activate File and print sharing (FPS)on each machine. Under the fps properties, turn off the browse master on one of the machines.
Next set the workgroup name to the same on each machine. After rebooting, you should see the machines listed in network neighborhood.
Now, in WinExplorer, right click on the drives that you want available and select sharing and name the share. The same share option should be available for the printers.
At this point, you should be able to browse and connect to the shared resources.

by cfburgess

Just post your additional questions as comments to my answers, it won't cost you any more points.

by the scruffy1

i agree with the above answer as i've just recently networked my 'puters if both puters have all settings the same you shouldnt have a problem.
if you are going to share drives and or folders dont forget to check or uncheck read only or full access

by jerilyn1

Two most important things:
1. Check the cable. A regular cat5 ethernet cable is best.
2. Protocol NetBEUI MUST be installed.

This discussion is closed to new replies.