If the Web Site is anything to go by.
http://tinyurl.com/26am48
So are we both talking about the same thing?
Now for the not so easy questions. What type of CPU do you have on this M'Board and do you have 133 SD RAM and not 100 SD RAM as that will stop the thing working faster than anything else.
When you inserted the CPU did it go in easily or did you have to force it in? If it's the latter there is something wrong so I would suggest pulling the CPU out and making sure than none of the pins are bent on it.
When you bought this M'Board did you pay to have it tested as this is an option which with good brand units just isn't available so I would be questioning the quality of the M'Board to start off with. Also being charged extra for the IDE & Floppy Leads and M'Board Drivers & Manual is unheard of anywhere unless this is a second hand unit which then would make quite a lot of sense.
You'll need the manual and see if there is the possibility to clear the BIOS with a jumper and see if that jumper is set to clear if it is what you are describing will be perfectly normal.
You'll also need the Manual to see how to configure the RAM as this M'Board only supports 1 GIG and it has 3 Sockets for RAM so you can only use 2 X 512 MEG Sticks which are dirt cheap now days but you'll need to know which sockets to put them into as they could stop the unit working if 1 is placed in the wrong socket.
Because this is such an old M'Board design you'll need the Manual and be able to read it to find out how it should be setup.
Col