Discussion Locked

IBM 300GL and ESS2838 modem

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a client with an IBM Personal Computer 300GL and an ESS2838 winmodem. The modem installs on com5 and diagnostics show it works ok. Dial-up networking says no modem is installed (also hyper terminal). I went to MKB and found a couple articles about rebuilding telephon.ini and confirming a registry entry at HKLM-software-Microsoft-Windows-current version-telephony. Did what was suggested and it had no effect. Flashed BIOS with no effect. Reinstalled modem and dial-up networking with no effect. If you have seen this problem before and know of a solution I would be grateful for your help.

6 replies

by mshavrov

What OS do you use? Do you use original drivers files? Did you try to download new drivers for the modem from the ESS website? I have experienced similar problem with USR Winmodem, and all problems gone after I found original drivers for my specificchipset. But I tried 5-6 different drivers and spent 3 weeks before I fixed the problem.

Good luck.

by mdelyea

OS is win98se - modem is Pine (www.pinegroup.com) with ess chipset and I have the latest driver installed. I have also replaced the modem with a later model and the problem persists. I am going to try a hardware modem eventually, I'm just irked about this problem.

by edison234

Windows Dial Up Networking does not like COM ports above 4. Remove the installed software via Add/Remove Programs. Then remove the device from the Device Manager. Next, shut down the computer, disconnect power and remove the card from the computer. Make a note of what slot the card is installed. After you remove the card, reattach the power cable and boot the computer to Windows. If your software for the modem is a SETUP application that steps you though install, run it. If the software for themodem is an INF file, go ahead and shut down the computer again and disconnect the power cable. Next, insert the card again this time using a different expansion slot. Reconnect the power cable and boot to Windows again. Windows Plug and Play shouldrecognize the card again. If you have installed the software for the modem via a SETUP program, Windows should automatically associate the hardware device to the software. If not, Windows should ask you for a driver. At this point you should only have to browse to the location where you have put the software (a diskette, downloads folder, etc.)

This is a general rule I use when I have hardware that does not configure properly.

Ususally its the different slot that reassigns the resources, but removing the software will help too.

Good luck!

This discussion is closed to new replies.