Discussion Locked

IBM 300GL model 6282-69U

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My pc will not boot up after reinstalling Win95. it will have a blinking cursor on the top-left of the screen and a number 67 to the top-right side of the monitor. It will not allow me to go to the BIOS config. nor it will boot up with a floppy or CD. please Help!!!!

3 replies

by willcomp

For IBM PS/2 models, error code 67 reported a hard disk configuration error.

Try disconnecting hard disk and see if PC boots. If it does, reconnect hard disk, ensure that cables are seated properly, and reboot.

Dalton

by Member 29605194

remove the hdd from the system. boot up w/o hdd. Clear the cmos and set new ones, saved it. is the win95 fresh install i.e. not a ghost image? have u set partition active for the boot partition c: (set active). is the hdd capacity too high for the bios to detect? some of this bios has a 20GB limit.

This discussion is closed to new replies.