Question Locked

IDE and SATA

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running Win XP. I have a 160 gig C drive. I have this drive partitioned once and I have it as IDE master. I have a 320 gig drive attached to SATA 1. This drive is not eing recognized by the computer. How can I get the comp to allpw both types of drives at the same time.

Thamks

3 replies

by captbilly1eye

Typically, the reason a drive is not recognized is because of an incomplete or faulty driver installation or an improper selection in the BIOS. Check your BIOS to see if the drive is listed there as an alternative boot device. Not that you want to boot to it but just to see if it's listed.
EIDE drives and SATA drives can be used together. In my personal system, I have two 200gb SATA drives in RAID 0 and one EIDE for backup and the swap file.

by hal 9000

If that's installed is the SATA Drive Formatted up?

If it's a new drive that has never been used previously you need to format the SATA Drive by entering the Control panel then open the Administrative Tools then the Computer Management then click on Disk Management the right click on the unformatted drive and chose the format option. It's here that if you want to you can chose to break it up into partitions of just format the entire drive up as 1 partition. You just need to follow your nose from here as everything is straight forward once you get to the stage of Formatting the drive. While the Drive is being formatted it will appear at the top of the drive list and say Formatting when it's finished it will come up with the next highest available drive letter and that will be your SATA HDD.

Col

This discussion is closed to new replies.