Question Locked

identifying cat6 cables in the hubs

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have a building of about 25 pcs and 3 dumb terminal users. On the wall next to everyone's desks is a RJ45 socket with a number on it e.g. A17 and in our computer room we have 2 hubs labelled Upper and Lower, each has about 40 ports on them.

I have a cable tester which I could plug into the cat6 cable next to the users computer desk and locate the cable plugged into the hub and detect which is the correct end to the length of cable but unplugging 25 cables for every user is a pain in the neck.

Is there a simpler way either by another piece of hardware or software that could do it? And if so what is it and where can i get it?

And yes we should have noted all connections when the hubs were first installed but we didn't.

Thanks
bruce

4 replies

by bldsm

sorry for some reason it posted twice

by ozi eagle

usually the hubs have LEDs to show connection and traffic.
Unplug each user individually and note which set of LEDS goes out.
Probably easiest for two people with mobile phones to communicate which user is being tested.

Herb

by howied

most testers have the ability to flash the LEDs on the switch end, so you plug it in at the desktop and then trudge back to the switch and see which port is flashing..

This discussion is closed to new replies.