7 replies
by gediboy11 Accepted solution
by markp24 Accepted solution
Hello,
You may need the a Dos Boot disk with the correct CDrom driver loaded in the config.sys.
The Windows 95 boot disk comes with a generic ide driver, it does nto work for all cdroms.
if you can access the hard drive with the dos bootable disk , edit the c:\config.sys, see what driver is users (ie device=c:\windows\CDROM.sys) then copy the sys file to your bootable floppy disk and add the same line to that config.sys. (a:\config.sys)
After that check the MSCDEX line in the autoexec.bat and make sure the same line is in you a:\autoexec.bat of the bootable floppy
once you boot with those, you should get a drive letter assiged to the CDrom (ie E:) and you can type e:\setup at the command prompt .
good luck!
by kenone Accepted solution
by markp24 Accepted solution
by seanferd Accepted solution
The HDD may have issues which cause it to not boot other than corrupted boot files or boot sector. You can usually download the test from the drive maker. There are still tests that run from DOS on bootable floppies.
If the drive maker has been bought by another company, the test is usually still available at the new vendor's site.
by gediboy11 Accepted solution
Thanks for your coments, i will try and atempt this, tho i have not realy got a clue about computers. You dont by any chance have a link where i could download a test cd? my system is Gateway 2000 intel pentiam processor LP mini tower, amibios 1992. If i can remember right i think it was windows 95 that was on that.
Many thanks .
by gediboy11 Accepted solution
Thanks for your coments, i will try and atempt this, tho i have not realy got a clue about computers. You dont by any chance have a link where i could download a test cd? my system is Gateway 2000 intel pentiam processor LP mini tower, amibios 1992. If i can remember right i think it was windows 95 that was on that.
Many thanks
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending