Discussion Locked

Install 98 to replace NT

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Inherited a computer with NT Server loaded and would like to replace with 98.How do I start (and finish)?Or where can I find "STEP BY STEP" ?

3 replies

by l_redstar

You can do this in 2 easy ways:
1)Boot from a Win98 CD, chose "Boot with CD-rom support", run "fdisk", delete the NT disk partition(s), create new partition(s), reboot from CD, run "format c:" (and format the others partitions if exist), go to win98 kit directory on CD and run setup.exe. After that you follow the instruction and DONE !
2)The same way like 1) but you can boot from a WIN98 startup disk (You can create one on a win98 computer from "ADD/Remove Programs;Startup Disk;Create").
If you have any other questions feel free to contact me at l_redstar@yahoo.com

by wpteh

The following is 5mm style of installing Win98, it is definitely not the best but it is how I do it :

Requirement :
1 BOOTABLE Win98 diskette. Other than the default files, make sure FDISK.EXE, FORMAT.COM and HIMEM.SYS is in it.
1 Win98 CD

Steps :
1) Insert your bootable Win98 diskette and boot from it. *You might need to do some changes to the BIOS to boot from diskette drive.*
2) Normally, the Win98 diskette will prompt you 3 options. Press F5 at this instance to go into 'clean' mode.
3) FDISK your harddisk, remove all partitions and re-create your own.
4) Reboot the PC, with your Win98 diskette still in the drive.
5) When prompted the 3 options again, select 'Start PC with CD-ROM support'. The diskette will then load the CD-ROM drivers and bring you to A:
6) Type FORMAT C: /S (This option allows you to format the harddisk and transfer the system files, thus making it bootable at the next startup.)
7) After format completed, copy HIMEM.SYS to the C drive in the root directory ( C:\ ).
8) At the C prompt, type COPY CON CONFIG.SYS and press enter. It will bring you to the next line. Type DEVICE=C:\HIMEM.SYS and press enter. Press CTRL-Z at the next line and press enter, it should display '1 file copied.'
9) Next,make a Win98 cabinet directory by typing MD WIN98CAB and press enter.
10) Since the PC have loaded the CD-ROM driver, you should be able to access the Win98 CD. Copy all the files inside the Win98 directory from the CD to the WIN98CAB.
11) Take out the CD and diskette, reboot your machine.
12) It will take you to the C:\ prompt, go to the WIN98CAB and type SETUP for your Win98 installation.

Using this kind of installation will ensure that you no need to insert Win98 CD again in the futureif there is any program which might prompt you to do so.

Good luck.

5mm.
Singapore.

by nils_hess

Looking at the previous posts, I would still recommend, that when you use the Fdisk command , also issue rund fdisk, from the command prompt using the following switch, to ensure that the MBR(Master boot record is also recreated.
"fdisk /mbr"
Makesure though that you boot from the Win98 Startup disk or Cd.

This discussion is closed to new replies.