Question Locked

Install a Samsung SATA DVD drive on A7N8X-E Deluxe

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,
I am trying to install a Samsung SATA DVD-RW drive, SH-S183A, on an already installed Windows XP installation -- with an A7N8X-E Deluxe motherboard -- but it doesn't get detected after Windows has started up.

My 3 hard disks are all connected via the IDE 2 channels, the DVD-RW will be the only SATA device on the system. I have tried both SATA1 and SATA2 channels, but no cigar...

Thanks in advance!

3 replies

by justelund

A bad case of RTFM, I am afraid...
I'll post the solution, if somebody else is having the same problem.

On page 2-17 of the manual, it reads: Serial ATA setting(3-pin SATA_EN1) and a photo of its location.

After I set it to Enable it finds the DVD drive and all is fine.

by ggfisk

I am able to install driver for SI3112 but after reboot it disapppears and I have to install it again.
I get an error message that windows cannot install the driver, but I can get to my SATA DVD then.

This discussion is closed to new replies.