Question Locked

Install pc3200 windowxp/boot issues

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

First off I have read the other post on here about the ram issues with no booting to windows. So plz no flames on not reading the other post about the same issue.

Where their questions end my question begins. I have a GA-K8NSC-939 mobo and has AMD 4000+, have been running 1gig running in DDR1 and DDR2 for a long time, with zero problem. There was a sell, picked up 2 more sticks of pc3200 512mb. Installed and it locked up at window screen.I get bunch of odd scrambled lines sometimes. So I booted in safe mode and it loged in. Looking at system info it see the 2gig of ram.

With the the ram 2 sticks are made by differant Co. So I keep them in the same color slots. In the boot up I see that it scans the ram and it says OK, and duel channel is enabled.

After reading with the other issues, i see that nothing is really said after, "are you able to boot in safe". because I am able to do so, and ram is seen. So is there a conflict in windows? possable driver?

5 replies

by k.sthalbaum

Ok what is the speed of your old Ram?.....
Also have you tryed just using the new RAM by its self to make sure that it will run by its self cause if it dosen't then the RAM is defective.

by crazyiven

all are 400, and yes they both work. When install in any cofiguration. Was talking to someone, that said there is a set up in msconfig, under boot.ini. says that sometimes window will only see somuch ram due to the default setting. Im at work and have yet to see if that is the problem.

Sounds like it might be due to the fact that I can see the 2gig when I boot in safe mode.

by crazyiven

And that didnt work, I have some other ideas. Sence this isnt grabing any atention, I wont be checking this again.

So thanks for the one reply

by k.sthalbaum

Hopefully you check this, but your mobo the GA-K8NSC-939, Has Known issues with DDR400. The BIOS for some reason on those mobos dont like 400, so they will run them at a slower speed. ( 333) This is a glitch with Gigabyte. Sorry for the slow reply. Still looking into it tho if you ever check this. Also it has know issues with AGP slot and deteching HDD's over 350GB.
Also if the ram is Dual Channel you might to put the DIMM into Slots 3&4 and the other two into 1&2 try that then let me know

This discussion is closed to new replies.