Discussion Locked

Installation of NT4.0

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Using fdisk I partitioned my 24gig hard drive into three partions, one FAT, one FAT32 and one NTFS. I formatted the FAT (C:) partition, made it active and installed WIN98SE. I then attempted to install NT4.0 on the C: partition. I used the three installation disks and the CD. When I inserted the CD I received a window that showed my drives. It showed the FAT and The NTFS as it should but each showed that the disks were either not formatted or corrupted. Supposedly NT could fix this but when I tried that it said NT could not perform the operation and to exit from setup.
I even tried redoing the whole operation and just installing NT4.0 with exactly the same results. Any ideas? Because of security and networking considerations, I need NT.

7 replies

by jimbb

Don't make life too hard on NT. Try making just one partition first - FAT16. Install your Win98 on it FIRST, and then NT. Only later try adding partitions.

One word of warning: installing NT and Win98 on the same partition is a pretty bad idea, not so much for the operating systems, but they will most likely share things like "c:\Program Files", and you risk corrupting NT's applications by installing Win98 apps and the other way round.
Better is to have a small boot partition, FAT16, andit can even have Win98. Small, as in 1-2 GB. A second partition, FAT16 or NTFS, can hold your NT, installed AFTER Win98. Both partitions, and any other partition that contains on OS which you'd like to boot, should be below 8 GB on your disk, anypartition having 1 byte above that will not boot. The rest you can use for data, either FAT16 or FAT32 or NTFS. So, for example:
0-1 GB : FAT16, Win98, Boot manager installed by NT to choose your OS.
1-7 GB : NTFS, WinNT
8-24 GB: FAT32, Data for Win98

Important is to install Win98 first, let the NT install make a nice boot menu afterwards, and only then add other partitions.

Jim

by dmiles

Using FDISK use Fat ot FAT16 to start,donot enable large disk support,enabling large disk support automattically sets a FAT32,so answer "No" when asked to enable using one file sytem will format the whole drive,the way you described you would have to format each partition seperately,you can go back and convert the partitions after setup.

This discussion is closed to new replies.