Discussion Locked

Installation of SCSI controller in NT4.0

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to install NT40 server on a Compaq ap550 with an Ultra3 SCSI controller. It recognizes the controller initailly then says there are no drives connected to the PC. Does anyone have a solution to get NT4.0 server to install the controller to recognize the drives?

1 reply

by jgraham

If this is on inital setup of NT 4.0 then when the Blue Screen starts press F6. This will bypass the loading of other SCSI drivers. i.e. Adaptec which will interfear with the ap550 SCSI driver.
Once the drivers are loaded then proceed. The OS should recoginize the drives after that.

This discussion is closed to new replies.