Discussion Locked

INSTALLING MULTIPLE NETWORK CARDS

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I'm new to Windows NT 4.0 (server), could somebody point me to where I can get information (preferably on the Web) on how to install multiple network cards? I am using TCP/IP. Basically, I want to use my server as a proxy server.

How can one verify that both the network cards are properly working? Windows NT doesn't seem to provide the device manager used in Windows 95/98. (I later learned that it is common to install NT over Windows 95/98 so that one can recover this functionality, but it was too late.)

5 replies

by ebob

1 - Sure there is "device manager" in NT4. It's in Control Panel, under "System", I believe. It's a little bit different from the "consumer versions", but not so different that it's a show stopper. Specific to NICs, right-click "Network Neighbourhood" and select "Properties" to being up the Network CPL.

2 - Just install the 2nd card, and configure it. It's pretty easy to test. Just unplug your "inside" card. Can you see your "outside" network? Then you're successful. Plug your "inside" card in and unplug your "outside" card. See your "Inside" network? Congrats.

by jcox303

I don't know of a web site off the top of my head, but this is fairly easy. I'm assuming that you will set up one one NIC for internal LAN and one for external internet. After you have installed both NIC's, go to network properties in control panel,protocals, tcp/ip, properties, and enter your info for each NIC. Use the drop down selection to change between NIC's.

This discussion is closed to new replies.