Discussion Locked

Installing NIC on NT machine

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am attemping to install a 3Com 3C905 or Linksys LNE100TX network adapter on an NT Server 4.0 machine (SP6a). Once the driver is installed, the NIC appears under the network adapters tab in Network panel, although I receive a message in Event Viewer stating a device attached to the network adapter is not working properly. I have attempted to install different NICs during both the NT 4.0 installation process as well as after installation, but NT doesnt appear to find the NIC.

Thanks,

Dan

7 replies

by gary mcp

Dan,
It sounds to me like you have a resource conflict somewhere. Does your machine have any "unusual" hardware? Try setting the NIC up with a different IRQ or base memory address.

Hope this helps,
Gary

by techdictator

You may have to switch the NIC from PNP mode to static. There should be a utility on the driver diskette called 3c905cfg.exe. You'll need to boot to DOS to configure the NIC with the utility. It can also test the NIC to ensure it is operating correctly.

by netspawn748

You know, I had the same problem with my win box....
But as soon as I got a different card that I knew would work on a nt machine(netgear 310tx) they have defined drivers for that os.. You really should not have had any prblems with the 3 com!! Im suprised!!
But never the less, try that netgear or get the newest nt driver for that 3 com@http://www.3com.com/products/en_US/prodlist.jsp?tab=cat&pathtype=support&cat=20&selcat=Network+Interface+Cards+%26+Adapters&family=624

hope all this helps!!

This discussion is closed to new replies.