Discussion Locked

Installing NT Server on NTFS partion

0 helpful
15 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a NT 40 member server and I am trying to make a new install of NT so that I can make it a BDC. All of the partions are NTFS. When I do this, the new installation tells me that I have no c:\drive and it can not continue with the setup. Can anyone help me around this? I am not trying to upgrade it, I am making a new install.

15 replies

by turambar386

Hey Virginia. You need to start the process by booting the computer using the three Setup disks rather than booting directly from the CD. That oughta do it.

by dmiles

More info about the drive it self would have been a good help to narrow this down.
1)If the drive is larger than 7.8G,then the BIOS may not be recognizing the disk,you will need at least SP4 includes the updated ATAPI download from Microsoft to access.
2)Enabling Large disk support during the format will automatically set FAT32,which cannot be recognized by NTFS
3)You may can get around this by installing the drive as a slave in another machine with ntfs partition and then formatting.

by estebandelatorre

Hi,

The c: drive may have been created with fat 32 (use fdisk to confirm this) thus it wont be accesseable with NT.
Another issue may be a very large NTFS drive which may leads to this errors.

Start from a bootable disk, run fdisk.exe , when prompt for enable support for large disks, choose no. If the partition is a FAT32 one, just delete it.
Boot from nt's cd rom or with the 3 disks, and start a new instalation, selecting a fat 16 partition no more larger than 2 GB.
Once the instalation is finished, you can convert.exe the fat16 partition into an ntfs partition and then extend it's size.
The setup role of the server should be BDC

by estebandelatorre

Note: You may have another partition fat32 in the same machine, but the active partition (the c: drive) should not be fat32.

by curacao_dejavu

Boot from the 3 floppy disk,
If your harddisk is bigger than 8 GB you will need the following artickle.
MS KB Article ID: Q197667

You can delete and recreate the partitions again.

Leopold

Installing Windows NT on a Large IDE Hard Disk

by michaeltubs

Boot from Cd or from boot disks it does not matter. With a new install delete the current partitions that you have as NT4 will convert them when installing. If you have a large disk there is an updated ide controller sys from Microsoft that will allow a primary boot partition to be 4 gig. If these disks were from another machine then they are marked in the boot sector and must be re-patitioned. Hope this helps.
P.S. When it is installed and you install a service pack 4>6 you can create anotherpartition of any size.

by bhrdwh

Hi,
The problem is you have FAT32 partition & NT wont install on it.
1. Boot from Win95 boot floppy having FAT16.
2. Run "FDISK", delete all partitions
3. Create one 4 GB & make it "Active"
4. Now boot from your NT Boot flppies & follow teir instructions. CD Drives will be autoloaded & then you can install NT as BDC.
Akash

This discussion is closed to new replies.