Discussion Locked

Installing NT4.0 Server

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
hi! I am having a problem during installation.I have PIII Compaq Tower.I use restore CD of Compaq.I make Fat partitions through Restore CD.I give NT4.0 server CD and Service Pack4.0 , when asked , then restore cd operation is finished and it says totake out the Cd so that NT4.0 server Installation can be resumed , The Installation starts and then in the start it gives big Blue screen message "Inaccessable_Boot_Device" with lots of zeros 1s and 2s.Please help

9 replies

by trurod70

Use Fdisk and delete the partition first before installing NT. You must use FAT16 because FAT32 wont work with NT

by jyimcse

Is your FAT partitions 2GB or less? Compaq has a small system partition on the hard drive. Your boot partition is the 2nd partition. Make sure that your boot partition is active.

by shmaltz

The above error means that the oprating system does not recognize the mass storage device its booting from (like if you have a scsi drive that nt 4.0 dosnt know about. You should get the latest upadates for your mass storage device controller (even if its IDE) and give it when the setup asks for it.

by zchris

do you have a raid-controller installed? if yes just type "F6" at startup and load the driver from a diskette.

hope this helps you

This discussion is closed to new replies.