8 replies
by eadk5 Accepted solution
by pcrx_greg Accepted solution
What is probably required, is the drivers for the SATA controller be loaded when installing from the windows disk. Put the drivers on a floppy disk and start the PC from the Windows Installation CD. When the install starts, at the bottom of the screen the message to "Press F6 to install a RAID driver", press F6 and put the floppy into the drive when you are prompted by the machine. Load the SATA drivers by following the on screen prompts, and Windows should then see your hard drive for you to install the operating system.
Greg
by eadk5 Accepted solution
by absolutely Accepted solution
by eadk5 Accepted solution
by jamesmondtan Accepted solution
by julian.bennett Accepted solution
In my experience, you really do need to load the drivers for the SATA drive during the XP installation. You may also need to ensure that your bios (if there is an option for this) is configured to enable the use of SATA drives.
In most instances i think your bios will be fine, but you definitely need to load the SATA drivers... get on the internet go to your hard drive manufacturers website, download and extract the files to floppy. Press F6 during the initial phase of XP installation and follow the instructions when prompted.
I'm quite sure this will resolve the issue.
by eadk5 Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending