Discussion Locked

installing windows98

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to install windows 98 on my pc, but it won't allow me to do it. My cmos has recognized it, and I partitioned and formatted thee disk properly. But as soon as it starts the process of installing win98 it gives me a "suwin" type of error. This is buggint the hell out of me cause I have another hard drive that works well with this pc.

5 replies

by parbo

Do a low level format on the disk. You can use the GWSCAN utility download from this location http://www.gateway.com/support/product/drivers/hdd/index.shtml
Use the option to write zero's when you're at the menu. Depending on the size of you're harddrive this might take a (long) while. Or if you are familiar with debug i can also send you the commands to it it works faster but a litlle dangerous if you make a mistake in the commands.

by mphoffar

I doubt this has anything to do with your Hard Drive. Usually when I saw this it came down to either a CD-Rom that's past it's prime or a CD-Rom that's starting to show problems.

You might want to try to copy the setup files from the win98 directory on the CD to a spot on the local HD and run setup from there instead of the CD-Rom. During the copying, if there's a problem, you at least get a message telling you can't read from source (if the problem is the Cd-Rom or can't write to destination (if it's the HD)

Good luck to you

Mark

This discussion is closed to new replies.