Discussion Locked

Internet Connection Sharing

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am trying very deligently to connect internet connection sharing. I have a DirecPC dish and I am trying to share the connection. I install ICS and when I reboot the PC tells me that ICS is disabled to check to see if ICS is installed on any client PCs. It is not. The PC direcpc is connected to is W98SE and I have 1 W98SE and 1 ME client PC. I have unsuccessful in any attempts to configure ICS. I have even read Microsofts notes on ICS no help.

9 replies

by mike o

A better solution would be to install some proxy software if you're willing to spend a little bit of money.

What you do is put a second NIC in the PC your satellite is connected to. The proxy then relays information from the Internet connected NIC to the second NIC for your second PC (or more if you have a hub and more PC's).

This is more flexible because you can use anything over that connection. E-mail, FTP, ICQ, messaging, etc. Many also have built-in firewalling and DHCP, etc.

WinRoute by Tiny Software (http://www.tinysoftware.com) isn't terribly expensive and is fairly easy to administer. I'm sure there are some freebies out there, too, if you look hard enough.

Good luck,
Mike

by ebob

I am not a fan of any of these software approaches. For me to use any of the other PCs on the LAN, I have to have 2 PCs running. And, the PC running as the gateway (whether ICS, Proxy, whatever) is impacted to some extent by the other PCs using its interfaces, services etc.

I do not know if any of these will work with DirecPC, but I really like the hardware "routers" typically used for sharing DSL/Cable connections. Does your DirecPC connect with an Ethernet cable? Is there anything particularly odd about the connection software from DirecPC. Perhaps you can approach one of the manufacturers (Asante, LinkSYS, D-Link, 3Com, etc.) and see if they have any specific product for this application.

These boxes provide switch/hub Ethernet ports (typically expandable to 253 internal ports), firewall capabilities, address translation (NAT/PAT), DHCP server, and optionally run as a print server and have a backup analogue modem port. Most for <$300, and falling.

This discussion is closed to new replies.