Discussion Locked

Internet connection sharing on Win2k

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Internet connection sharing on Win2k
I have a win2k pro machine with a 56k modem attached and the dialup has been shared but i am unable to connect from a win98se machine over a lan to the internet. I have used winproxy successfully before to provide internet sharing but it will not run unless i am logged in on the win2k machine as well.
Any help would be appreciated.

7 replies

by parbo

If i'm right with both solutions the w2k system has to log in since that's the system providing the connection (services) If you use ICS it will assign an IP address to the w2k system. Usually its something like 192.168.100.1 The subnet mask will be255.255.255.0 The W98 system has to be on the same network so its IP addr should be something like 192.168.100.x where x would be a number from 2-254 (you cant use 0 or 255) the subnet mask should be identical to the w2k machine. when you got all these settings right try to ping the systems. At the w98 system you type from a dos shell prompt ping 192.168.100.1 press enter and it should reply back with 4 responses. If that works you have a good connection. do the same thing on the w2k system butspecify the ip addr of the w98 system. Once you can accomplish this you should not have problems connecting to the internet.
let me know if this works for you

by dmiles

If you are using a crossover cable to connect ICS,the host computer will have to be connected to the Internet,so that the client can use the networking settings to connect.The ip address is shared from the host and the client uses the same TCP/IP
configuration

by dmiles

If you are using a crossover cable to connect ICS,the host computer will have to be connected to the Internet,so that the client can use the networking settings to connect.The ip address is shared from the host and the client uses the same TCP/IP
configuration

by agentk

If your ICS is setup correct, then you should be able to connect to the Internet via the W2K machine, hook up the W98 machine, making sure that the assign IP is set to auto, then in IE on the 98 system, go to connection settings and select "Dial only if network is not present".

Hope this helps

This discussion is closed to new replies.