Discussion Locked

Invalid Drive Specification for my CD-RO

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I had to format my harddrive. I am trying to install windows but i can't get my drivers for my cdrom to work. I narrowed it down to the problems:
1. I don't have the directory information for MS001 (or something like that(the cdrom driver directory))
2. I don't know what to do with MSCDEX.EXE
I run Acer 624A. Any suggestions?

5 replies

by stillatit

If you wiped the drive, you will not find the drivers on the drive. Your choices are:

1. Find the floppy disk that came with Windows. It will boot and either ask you for your CD type (Win95) or auto-detect it (Win98). There is probably such a floppy with Windows ME as well. Any of these will allow you to get into DOS with CD drivers active.

2. Find a friend with such a floppy.

3. If your computer's BIOS has the ability to boot from CD, change the boot order in the BIOS to attempt to boot from the CD first. The BIOS will supply its own driver in this case.

Once you have booted with the CD accessable, change the current drive to the CD, change the current directory to wherever setup.exe is, then run setup.exe on the CD.

Good luck.

by danpiers

The first answer to your question was very good, but the author left out the simpler solutions:
Find the CD-ROM driver (floppy)disk that came with your Acer and simply install it on your system at the DOS prompt.
If your system did not come with a CD driver diskette, but instead with a RESTORE CD (and possibly a RESTORE floppy, too), then that disk has the driver and will automatically install it during the Restoration Process.
If neither of these are possible, then follow the instructions in the earlier answer.

This discussion is closed to new replies.