Discussion Locked

Invalid Page fault in Win 98 SE#

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am trying to get Preplogic's A+ hardware practice test to work on an old PC:
200 MHz Pentium
64 MB ram]
13 GB HD

I get the following message when try to start the program:
TESTENGINE caused an invalid page fault in
module HPFWIN08.DLL at 0013:000064ca.
Registers:
EAX=11a70000 CS=5aaf EIP=000064ca EFLGS=00000297
EBX=00000000 SS=11a7 ESP=0000b870 EBP=0000b876
ECX=00000000 DS=5a77 ESI=00000000 FS=0000
EDX=00000000 ES=1897 EDI=00000001 GS=0000
Bytes at CS:EIP:
26 80 78 ff 3a 75 01 4e 56 06 53 66 ff 76 0c 9a
Stack dump:
131f5b0f bc58016f 5b172a1c 00000080 bb2a1897 05c711a7 016f131f 00470000
00017570 8168cd54 8168cd54 0069e8cc bff7c8a0 81617a50 0000008f 8168cd54

Any help would be appreciated.

Thanks,
Johnnie Ellis tarwillie1@yahoo.com

3 replies

by hal 9000

While I'm not personally familiar with that app do you have enough system resources to actually run it? That error message looks as if there is a lack of RAM available to run the app and it is failing. That could be either physical RAM or your SWAP FILE which may be too small for the application to run particularly if you are running low on HDD space the Swap File could be limited in its ability to open up and accommodate the extra space required. Or it could be set to a custom size which isn't big enough for the app to run correctly if that's the case just altering the Swap File to allow Windows to manage it should cure your problem.

Col

by jmellis

Thanks for the suggestion.
Good news though, I was able to get the program to run last night by running msconfig, choosing selective startup and by processing only the config.sys, and win.ini files, the program ran.

I also took out most of the startup items in the system tray through msconfig. Appreciate your suggestion, I think I will partition the drive into 2 drives.

This discussion is closed to new replies.