Discussion Locked

Iomega Zip drive on a Dell Optiplex

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I installed an Iomega Zip 100 parallel port drive on a Dell Optiplex GX1. It wasn't recognised, so I got the latest drivers from Iomega, and installed them. It then worked.
The user hadn't used the drive in a few weeks, and when they went to store data on it, it wasn't seen.
Nothing new was installed on the PC. I tried removing the driver from SCSI Adapters, and re-installing it - but it still isn't seen.
Does anyone have an idea what might be done to fix this ?

11 replies

by acurrin

Confirm the drive still works on another machine. They have a tendency to die.

Also, try changing the printer port settings in the system BIOS to bi-directional and see if you can then see the drive. Some of the higher performance settings don't let the ports play well with others.

by lo

Hi - Just guessing but, ... I have had this happen on my Win 98 system now and then. Usually due to the fact that I powered and booted the system and didn't turn on the Zip drive prior to Win 98 getting into boot. Lo

by randerson

I would check the drive letter assignment for the zip drive. It may not be showing up because the drive letter assigned is already being used.
I hope that helps.

by zephyros

I've installed parport Zips on OptiPlex GX1's that ran NT4. Received intermittent BSODs fingering SCSIPORT.SYS until I reapplied Service Pack. If using NT4 you can go to CTLPANEL/DEVICES and look for status of "ppa3nt" the driver. Startup mode for it should be set for "automatic" and "boot".

This discussion is closed to new replies.