Discussion Locked

IP Routing

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I created a routing table for a WAN I administer and all was good. Then the power went down and I had to rebuild the routing table from scratch. This happened three times in a week. I'm looking for a perminent way to create this routing table that will not be lost everytime the power cycles. I have created a batch file which restores the routing table quickly but I do not see the necessity of manually restoring this table each time. Surely there is a way in NT 4.0 to do this more perminently.

9 replies

by bsanford

Backing up the route table is an option but why dont you have a ups on the server and router if your using one? Servers, routers, hubs, etc need never go down.

by acgphx

We have a sizeable UPS on each server but when the power is down for 1+ hours its hard to compensate.

by bsanford

Backing up the route table is an option but why dont you have a ups on the server and router if your using one? Servers, routers, hubs, etc need never go down.

by acgphx

We have a sizeable UPS on each server but when the power is down for 1+ hours its hard to compensate.

by ntoz

when you create the route, use the -p switch so its writen into registry as a persistant connection. If you dont, its only temporary.
-P When used with the ADD command, makes a route persistent across
boots of the system. By default, routes are not preserved
when the system is restarted. Ignored for all other commands,
which always affect the appropriate persistent routes. This
option is not supported in Windows 95.

Pete

by acgphx

Thanks for the input. We are already using the exact method you mentioned. I was hoping to do something that offers more control over what gets mapped. We are picking up additional routes that were not set by us. That is a concern so I fgured if there were a way to build a table and ensure that only the routes from the table we create is included in the systems routes we should be OK. But it doesn't seem there is any other method than the one we are already using. Thanks again.

This discussion is closed to new replies.