Discussion Locked

Lava Parallel port NT

0 helpful
21 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am having trouble installing a lava parallel port on WIN NT. Can't seem to find the printer.

21 replies

by fred king

Check that under Systems in the Control Panel that LPT2 is setup.
Its under Device Manager - Ports
If not goto Add New Hardware in Control Panel and add LPT2

Good Luck

by blair.mcfarlain

I have used these before, the diagram / documentation is wrong for the jumper settings.

Make sure the IRQ is set to 5 and that nothing else is using that IRQ.

Set the Port address to 0278

It is labeled LPT3 on the board itself, it is mislabeled, it is actually LPT2.

Try this and see if it works.

Blair

This discussion is closed to new replies.