Windows Forum

Ask something
Discussion Locked

linksys brigde

0 helpful
4 replies

by didluck

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have a wet11 linksys brigde that iam trying to set up on to wireless isp server but iam not having very good luck.the office that iam trying to set it up has about ten pcs.the signal is coming to the brigde and form there is going to a dlink router ,but iam not sure what kind of settings i need to put in for this brigde to get me a wireless signal.any ideas would be appreciated.

4 replies

by willcomp

Note that entire URL is not highlighted above, you will need to cut and paste into browser.

by lmon

First thing you need to do is go into your router's configuration page. open ie and type 192.168.0.1 and hit enter you should then get a dlink login screen. If you did not change change it when you configured your router just enter admin for user and hit the okay button. Find your ssid name jot it down along with wep if you enabled it and the channel. Remember to write them down exactly as written. Close ie.

Get your and run the cd. Your network type should be infrastructure. Your next screen should ask you about the ssid write down what you wrote on the paper for ssid. The next question should be something about dhcp. Select obtain ip automatically. then you will be asked about security that would be wep. then save the settings. Once the light is wlan light is lit you can plug in what needs to be plugged in then you should be on the network

by choppit

The wireless bridge needs to be associated with your router (which I assume is also wireless?). Then, Connect the WET11 to a hub or switch and from there to your PCs. Unless you're using static IPs on your LAN I'd sue the Dlink to provide DHCP.

This discussion is closed to new replies.