Discussion Locked

locking up at startup

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm running win me and when i leave my pc off over night and try to boot up ,it frezzes up on the me screen. I've to use msconfig and nothing.i've tried to find a dos or memory virus scan prg. but without any luck..any help anyone

13 replies

by dmiles

Try running scan disk for errors and check to see if screen savers are loading at start-up
You may have vierus scan enabled to scan at start-up
Up date the video drivers to see if this corects the problem

by consortech99

Have you checked you video properties and checked out the power management items. I think you might want to put them on.

Get back to me

Clarence

by roland63

If you're talking about an HP, that alone may be your problem.

Local vendor finally admitted to a "bad batch" on the 3rd (that's right - third) return of 3 different (same model & config) computers - not even their techs could figure it out.

Good luck.

by sflyfish

My pc is about 30 months old and it just started this around the end of nov. or the first of dec. but you could be right about it maybe a hp thing

by kmerrillt

This is very common with HPs. It sounds like you're system isn't loading one of the drivers at startup. Do you have a startup floppy? Try starting with this. In your MSCONFIG try starting with "diagnostic startup". This should pick up all the drivers and also tell you if a driver has a problem. Did you update from an earlier windows OS to ME? This could be the problem too.

by consortech99

Well, after thinking about this problem I think that you might have a program running in the background. Check the system tray and remove all the short cuts there. Also go to CMOS and check the Power management setting. If they are on turn them off.If all else fails try to restart the computer and as it is restarting hit F8 or ctrl and few times until it gets you to the Windows ME Safe mode. Click on the number that follows step by step setup. Look to see if there is all VXD file that halt thesystem.

Good luck
Clarence

This discussion is closed to new replies.