Discussion Locked

Log on to a Domain in different segment

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have an NT Member server in segment 192.x.x.x and I have a PDC in segment 10.x.x.x. The gateway between the two networks is a Checkpoint firewall. The 10.x.x.x network is NATed to 12.x.x.x

The question is:
How can I log on to the PDC domain from the 192.x.x.x segment that is behind a firewall.

4 replies

by ntoz

First you will need to have a WINS server and its address configured in each server or worksation. You can manualy do this, or if your using DHCP, you can configure it in the scope. Another method would be to put entries for all hosts in both servers and workstations lmhosts file, located in {Drive Letter}:\%SYSTEMROOT%\system32\drivers\etc if you have never inserted on, there is a sample called lmhosts.sam you will need to have a file called lmhosts with no extention though. Once these are in place. Secondly you will need to open ports:

PORT 135 (TCP or UDP) for Remote Procedure Call(RPC)Service
PORT 137 (UDP) for NetBIOS Name Service
PORT 138 (UDP) for NetBIOS datagram (Browsing)
PORT 139 (TCP) for NetBIOS session (NET USE) ALL PORTS above 1024 for RPC Communication

Depending on how many users you have on each subnet, it might also be a good idea to have a Backup Domain Controler on the second subnet. Its always a good idea to have a BDC anyway if you dont currently have one. This information I hope will help you. For more detailed information see

This discussion is closed to new replies.