Discussion Locked

Losing CD in Reboot

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a box with Windows 98SE, 96 MB RAM, Pentium 233. The problem is that while the box recognizes the CD upon cold boot (power off/power on), it fails to recognize the CD whenever I do a warm boot. Any ideas on a bios setting which may be causing this?

8 replies

by krunch

Hello,

First I would download the latest cd-rom driver and save it off in a folder. Next, I would go to start/settings/control panel/system/device manager tab and open up the cd rom tree and remove the cd rom. Now when you re-boot use the latest cd rom drivers you just downloaded.

HTH!

by biju thomas

This is happend to me also. What you have to do is from control pannel use add new Hardware and install CD-Rom drive. Secondly in config.sys just add one more line "Lastdrive=Z".Now reboot the system and enjoy using the CD Rom. Thank you

by pxttocyob

On a cold boot the hardware is setting the IRQ and IO resources correctly. On a warm boot, the plug and play is using it's own settings to override the computer erroneously.

by toml

The answer was not complete. No instructions were provided on specific actions. I appreciate the help but I did not know how to proceed.

by mark_richmond

In W98 go to start->run and type MSCONFIG and press enter. this will bring up the system configuration utility. Set to selective start and uncheck the boxes for config.sys and autoexec.bat. Press OK & allow the system to restart. If CDROM access is stabilized there is something in one of these two files that is causing the problem. If there is no change go back to start->run->MSCONFIG and uncheck win.ini and load startup group items. Restart & check again. If there is still no change go to start->run and type SFC. This will launch the system file checker. Allow it to scan for altered files and replace anything it thinks is bad. If there is still no change I think we are left with reinstalling W98. It will work better if the old W98 is removed first, either by deleting the Windows directory or formatting the drive. Make backups first. If at some point the drive starts to be picked up correctly, go back to the MSCONFIG and recheck one of the two items that were just unchecked, reboot & test it again. This will allow us to find out where the problem originates. There are tabs accross the top of the MSCONFIG window that correspond to each of the checkboxes in the selective startup list. For config.sys, autoexec.bat or load startup group you can check and uncheck items alone or in groups to narrow it down to one item. For the win.ini click the plus sign by 'windows' and uncheck anything that starts with run= or load=. Hope this will help you find the source of the problem. Then it's just a matter of updating or reinstalling the right thing.

by toml

This still did not work. I have found a conflict in the IRQs but it seems this may be related to a BIOS problems since the CD works initially upon a cold boot.

This discussion is closed to new replies.