4 replies
by brifd1 Accepted solution
by seanferd Accepted solution
All Macs use the HFS filesystem, that is, the "old" Mac OSes as well as the OS X class of Mac OSes both use versions of HFS. Hopefully, the older filesystem is readable from OS X if the G5 is OS 9 or earlier.
But for the physical connection, just get a drive enclosure for the HDD - you can get a USB or Firewire enclosure. I'd think the USB variety would be a bit cheaper than the faster Firewire, but I couldn't say if the differential is significant. USB 2.0 speeds should be plenty fast enough for your purposes, though.
Whichever you use, you simply plug the enclosure cable to the USB or Firewire port on the Mac. You put the old drive inside the enclosure. You just need to make sure that the data connectors on the drive and the drive enclosure match - if they are SATA or IDE connectors, and if IDE, sometimes laptops use a different laptop type connector than desktops. You can just buy an adapter for laptop to standard if this is the case.
You may be able to drop the optical drive into such an enclosure, but if this is a laptop optical drive, it may not work well or at all.
by brifd1 Accepted solution
by oh smeg Accepted solution
Also as both computers are Notebooks the G5 if I remember correctly has a 2.5 Inch Drive that should be IDE, so you would need a 2.5 Inch IDE External Housing.
The upside is that these 2.5 Inch Drives run on 5 V DC so you don't need a Power Adapter the USB Port will supply enough Voltage & Current to run the drive.
The only thing you need to know here is that the different makes of HDD's may require a different Jumper Setting. Some require that the Jumper be set to Master and some require the Jumper to be removed. This all depends on the Chip Set used in the HDD and the Chip Set used in the External Enclosure.
Something like the enclosure shown here should be what is required. ;)
http://www.newegg.com/Product/Product.aspx?Item=N82E16817816002
Just plug the drive into the Enclosure and the USB Lead into a USB Socket on the new Computer and copy the data off the old drive. If the computer doesn't recognize the Drive in the Enclosure open the enclosure after first unplugging it from the computer and remove the HDD, then change the Jumper to either Master or remove it and refit to the enclosure and then plug into the Computer. ;)
Col
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending