Discussion Locked

Map a drive letter to local dir/folder.

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I would like to know if it is possible to map/assign a drive letter to a dir/folder on the 'C' drive.

ie. map/assign drive letter 'M' to 'c:\temp'

12 replies

by masked man

sure it's possible
"subst M: c:\temp"
without the quotes
works under DOS WINDOWS 9x, NT, 2000

by masked man

needs to be done from the command prompt or added to autoexec.bat to map it at boot time

by pvp

Use of subst under Win 9x/NT/2K is a very bad idea!

I'd do it if I were VERY desperate to continue using older, irreplaceable software, but it's not recommended procedure.

by jdfcomputer

This is possible. You will need to install file and printer sharing. Right click on the folder you want to share. Then go into network neighboorhood and map the shared folderto the drive letter you want.

by tommugg

Answers #2 and #3 are right. #4 is kinda right, but that is to map a new drive to an entire "real" drive, but not just a folder. I used this same scenario when networking a old DOS package, the ini files needed a drive letter installed, so one machine in the LAN mapped to M: and the machine "M:" was on, was done with a subst m: c: in the autoexec.bat file. Therefore all ini files were written with a M: in them and thus both machines could use the program, but not simultaneously. But #3 is kindaright, there isn't much use for that anymore.
Good luck!!!
-tom-

This discussion is closed to new replies.