Question Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had a 40GB WDD with XP in it and want to use as a Slave. I got a 160GB WDD and loaded XP with SP2 on it and want to use it as my Master Drive. The system recognises the Slave but shows it having 7GB only. I tried different configurations explained in WDD site. No luck. Can anybody help
3 replies
by bnkurien Accepted solution
Clarifications
by meridenscrafts Accepted solution
Did you check your jumpers?????
Make sure they are in the right place. One is a master and the other a slave, Just reverse them
by ozi eagle Accepted solution
Hi,
As well as setting your jumpers to master / slave, the master drive must be the one at the end of the cable and the slave in the middle. The master terminates the wires in the cable, and if placed inthe middle you may have read / write problems.
Herb
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending
Question Locked
Setting up a wifi bridge with switch correctly
0 helpful
5 replies
Question Locked
Experiencing Bottleneck with RTX 4060 + i5-12400F - Need Advice
0 helpful
5 replies
Question Locked
Keyboard
0 helpful
3 replies
Question Locked
Core i7 12700KF or Core i7 12700F ?
0 helpful
9 replies
Question Locked
Looking for honest opinions on gaming PC
0 helpful
5 replies