Question Locked

Minimized remote session pops up on it's own

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This is an issue we have been having for about three months or so. We have one computer that periodically has its minimized rdp session pop up on it's own. I know this sounds like a network issue, that's what we said from the start, thinking it would just be trial and error to find the networking component that is the culprit. However, we have run a packet test on this computer multiple times, once, over an entire weekend, with the same results: zero packet loss. Problem continues.

Here are the additional steps we have taken: 1.) changed out the NIC card,
2.) Changed the faceplate in the wall
3.) The Cat 5 cabling from that office to the patch panel
4.) The patch cables from both the computer to the patch panel and from the patch panel to the switch
5.) changed ports
6.) purchased a 1 GIG switch.

We are not allowed to change out the computer or low level and do a reinstall, per this partner's instructions. Does anyone else have any ideas or thoughts on where to go from here? Any help would be greatly appreciated

4 replies

by triathlete1981

disabling av updates and all other software updates on the remote computer? maybe that's causing constant maximizing of the session window. also, does this happen with all computers you are remoting into or just one?

this doesn't sound like a network problem. sounds like an issue with RDP settings on the computer in question.

also, maybe it's not just an RDP problem. try using a different remote software and see if the same problem comes up. VNC offers a free remote software that's very easy to use.

by help

Thanks for your reply. I have the AV update set up for the same time each day 12:00 noon, so this is not the case.

This is the only machine I am aware of. This only means that nobody else has noticed or mentioned it. Like I said, it may happens a couple of times each day. I think the most freqent was 4 times, the least freqent 1 time. It does happen every day.

I have checked all the optional RDP settings, including editing the file and turning the autoreconnect option to off (0 instead of 1). This verified that it is losing connection to the server, at least for a split second,because it does generate the error message of a lost connection. It reconnects immediately, but it does happen.

I heard there might be a MSTSC client version that does not pop up when reconnecting, but have not been able to find it or identify which version that would be.

How does the VNC remote software work? Does it work in conjuction with Terminal services and just replaces the MSTSC command?

Thanks again for your help....

by triathlete1981

it doesn't replace terminal services.

it's a small install onto the computer you want to remote into (vnc server) and a small install on the computer you are remoting from (vnc viewer).

this is the download site for vnc free edition 4.1 - http://www.realvnc.com/products/free/4.1/download.html

when i say small install i really mean small install (~600 KB).

during the installation you get an option for installing vnc server and/or vnc viewer. on the destination computer, only need to install vnc server. once installed, go to start, all programs, vnc server, start vnc service.

you'll also have an option to configure vnc settings (such as password) - highly recommended.

then install the vnc viewer on the problem computer. a desktop icon'll be created, and enter the ip address of the remote computer (with teh vnc server on it). then enter the password you had already created. you'll get access. it's a free way to figure out if there's a problem with just RDP or any remote sessions.

and if you changed the bit in registry for RDP, i don't know anything else. maybe VNC, if it works, is a substitute.

This discussion is closed to new replies.