Discussion Locked

Missing LPT port

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
On a Win95 machine a user suddenly couldn't print one morning after no prior problems. I discovered the LPT port is now missing from the System Devices. How do I get it back? Thanks!

5 replies

by guidos

Windows should have rediscovered it when it boots. You can go to Ctl Panel, Add New Hardware...when asked if you want Windows to search, say no. From the list, select ports (COM & LPT), then ECP printer port. This should install the printer port for you, but just to be safe, reboot and make sure it's still there. Hope this helps you...

by stevebytes

Unfortunately, this didn't help. Printer ports, no matter which I try to install, still show up as "not working properly or not installed" after rebooting. Where did my LPT port go???

by jctech

It's quite possible that the onboard printer port has gone bad. If that's the case, you can either replace the motherboard, or purchase a plug-in parallel port I/O card. But first, I would check the BIOS settings for the parallel port to be sure it hasn't somehow been disabled in BIOS. Watch for an onscreen message just as you start to boot, and press whichever key the message indicates to enter BIOS setup. Then search through the menus for a setting for the onboard parallel port, and make sure it is enabled and set for ECP mode. Then reboot and if the port is okay, Windows should detect it and reinstall the appropriate drivers. If Windows still doesn't see it, then it is time to install an I/O card.

by stevebytes

That last response did the trick! Apparently the port had become disabled in the BIOS. Thanks for the support.

This discussion is closed to new replies.