6 replies
by danpiers
At the DOS level, you communicate to a modem directly through its communications port. There are four recognized ports available to DOS. Unfortunately, almost all PCI modems do not posess (nor present) a standard communications port in the hardware. They only emulate a "serial" port through their Windows driver/enumerator software. This is why they can wind up at very strange addresses, using any available interrupt.
Some PCI modems are partial (or total) Winmodems. Winmodems usually depend on the system's CPU to perform much of their work and often have limitations on the processor they will work with (listed in their requirements.) Many PCI modems are not Winmodems, but called "software driven" modems. These more or less "real" modems do not use the processor directly. A software-driven modem can work in an older 80486, as long as it has a PCI slot.
The bottom line is that unless the Windows enumerator is in play, most PCI modems can not be addressed. Hope this was helpful.
by m_ozog
My experience has been that DOS programs cannot communicate with PCI devices. Thay are only capable of "talking" with devices on a ISA or similar slot.
Matthew Ozog
Excellis
mozog@excellis.com
This discussion is closed to new replies.
Trending Web Development posts
Sort by Trending