Discussion Locked

Modem gets no dial tone only at home !

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I had to change a burnt power supply and reformat my disk and reload W98SE. My first HSP 56 Micromodem internal modem got no dial tone at home. I have bought an other one, a not winmodem, 3com USR 56k PCI: no dial tone . I tried elsewhere (two locations) to change phone line : my modem connects perfectly. I tried two laptops back on my home phone line: they connect perfectly. I tried two others internal modem aboard my PC with my home line: they don't connect (no dial tone). I try the laptop through the internal modem: it connects. I (and few colleagues) am running crazy... Any help how to check a phone line ?

14 replies

by ann777

Check your computer BIOS and IRQ assignments; check device manager...modems and ports. Sounds as if the one computer is tieing up the modem port and will not let it free for your real modem(s) to use it.

by seagull data services

I'm assuming you've already done this but if not you could also try using different PCI slots for your modem and a different phone cable.
Sorry if it seems obvious
John

by donmars

OK you have a phone line plug [A], your pc will not admit a dialtone there. your friends Colleagues can connect on [A], Two other laptops can connect there on [A]. Your PC works on other lines elsewhere. When you tried your PC elsewhere did you use the same phone cord? We know the phone line works at [A]. None of this makes sense except that the phone wire from modem jack to wall jack has a problem.

by donmars

Sorry... just read answer 2, phone line replaced three times. HHhmm... You are sure there is really no dial tone and it's not that you just don't hear it? Did you actually try the same phone linecord that does not work on [A](any of the 3) on the other lines you say works with your modem? You gotta take this one by the numbers one step at a time and record your steps. This is too crazy and I would like to know what the solution is when you find it.

by crouletosaure

I had plug the laptop modem on the modem phone exit. It connects through the suspected phone wire, thus testing connection correctness, while my modem did not connect itself ! I can place a phone call through it too :-), but not e-phone ;-(.
Correction: my friends colleagues cross-checked configuration, IRQ, BIOS, etc... but don't bring their own desktop to plug [A](my last test to-do), only laptops. Are laptop's modems more robust to signal quality (IBM Thinkpad and Compaq Armada)? How to check line quality ?

by paul d. masley

3-Com modems are a little picky. Try this. Open up your phone outlet box and switch the red and green wires. I ran into this on my own computer with the USR 56K PCI.

Paul.

by crouletosaure

Interesting but I have found the origin of my trouble : I don't think your trick (sound to me like repair to plant wiring error) will correct it.

by ravindra kumar chauhan

Click Start, point to Settings, click Control Panel, and then double-click Modems.
On the General tab, click your modem, and then click Properties.
On the Connection tab, click to clear the Wait for dial tone before dialing check box.

by meddjay

You asked how to check a phone line, so I am going to address that question exactly. You take a good corded phone (not cordless) out to the phone box at the side or the back of the house. (Sometimes it can be hard to find like in the attic or basement, you may not even have one believe it or not, or it may be on a neighbors property) but normally it is on the back or the side of the house (just look where the phone lines come into the house either from the ground or the telephone pole)then open up the box (you may need a screwdriver for this) you should see a small telephone plug just like in the house. Take it out of the plug just like you would inside your house. Plug in the phone set you brought with you. If you do not hear a dial tone at the box then that tells you the problem is somewhere out beyond the box which would be the phone companies responsibility If you do hear a dial tone and still have the problem then you know it is somewhere in your house wiring. Hope this helps! :)

by crouletosaure

Thanks for information, but I mislead you about phone line. I localized the trouble: my screen monitor generate strong electromagnetic interference ! I finally bring at home the whole desktop of of friend, monitor included : his modem connected 50k. I switch his screen to my desktop: it connected 50k. I plug my monitor on my desktop but left my friend's monitor switched on (with "no signal" display between my monitor and my desktop: it had connected 50k !!! I withdrew this electromagnetic shield: I got "No dial tone". Morality: don't believe anymore anybody who tells you it is useless to bring in your 17" monitor to test a modem !!!

This discussion is closed to new replies.