Discussion Locked

Modem not detected by WIN98 no responce

0 helpful
12 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a US.Robottics sportster x2 winmodem voice, WIN98 cannot detect this kind, so i got the driver and when installed still no response from the modem, when i try to connect a MessageBox saying that the modem wasn't detected or that the modem isn't responding. Thank you

12 replies

by trurod70

Go to the control panel. Double-click the modems icon and let windows search for a modem.

by saihib

Answer1 is a good start. You might also want to put the modem in a different slot. Many times a MOB will set a certain IRQ for a slot. This is especially true if it is the slot next to the AGP slot.

by ctr2000

The best answer i can add is, is your com ports enabled in your CMOS setup.
Also If you have any more information you could give us, like did this modem work before in this system or is it new, old etc. Thanks.

by mhang

Goto your CMOS.

Make sure that the option for Internal modem is off if there is one. Make sure that the jumper on your motherboard is set to disable an internal modem.

Some motherboards have a Modem Riser Port on their boards. So check it out.

Other than that, check all that needs to be done on this site.

by drew_lgca

First make sure you have the right drivers. Go to www.windrivers.com to find the right driver.
Remove the modem card. Then going into safe mode (hit F8 multible times during power up). Right click on my computer icon =>properties=>device manager=>remove (delete) any unknown devices and any device under modem. Next go to start=>settings=>control panel=>modem and make sure there are no modems installed. Shutdown and then reinstall the modem. Windows should ask for the driver disk. Put the drive disk in. If it does not ask for the disk, then go to the device manager and try upgade driver and then point it to the disk with your modem drivers on it. Reboot your PC. check device manager to make sure the modem is normal.

by amk_com

Sorry about the rejection some of them came by mistake (I really rated a lot of them but don't know what happened). Thanks a lot to drew_lgca@hotmail.com it helped some. but the answer to this question is that windows must identify the modem before you may install the driver. so you can take it out rerun windows without it restart and then reinsert it and rerun windows again but you have to have had deleted any modems in your modem directory in the control pannel. If this doesn't work then you have to delete the entries of your modem in the register the program to do this task for you is found in the windows98 cd-rom under the drivers/modems directory (choose the modem type) for me the program was named winmregcln.exe after this you must restart and windows must detect the new hardware then you point to the drivers you have. Thank you All for your trouble.

This discussion is closed to new replies.