Discussion Locked

modem pooling

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i am looking for some software to allow me to simultaneously connect two modems in a windows 98 environment, and send out the pooled bandwidth to me network via either my proxy server (sygate) or another, integrated proxy server. if this is a capability of nt server 4.0, let me know, so i can cross my server over. i am stuck in the sticks, and can not get a higher speed connection than 56k in my home for any less than a second mortgage, so i need to make this work.

11 replies

by erebs

The term Microsoft uses for this function is Multilink. It requires two modems, two telephone lines and an ISP that allows you to have two simultaneous connections (Creative Labs use to sell a modem card that had two modems actually on the card and their software allowed you to use two different ISPs).

If you install two modems in a Windows 98 system, there should appear a Multilink tab on the modem properties window from the control panel. Just click on this tab and configure the second modem (it's pretty self explanatory). Sygate just accesses your Dial-up network configuration, so just indicate via the Modem properties window or in DUN that it is to use both modems to establish the connection. Sygate isn't concerned with the number of modems used.

by wesleywillis

i am not seeing a multilink tab here anywhere. i remember the v112 shotgun modems, they were ok. do they need to be identical modems, because the two i have been using are not, but are co existing, and both dialing up at the same time, and connecting just fine, but no multi-link tab, do i need to re-install and specifically seek out this install option? it is 98se by the way.

by mphoffar

I was always the impression that you had to have a modem capable of bonding like that. Basically you just couldn't take two plain 56k modems and bond them to make a 112K connection (in theory). I beleive the DUN 1.2 addressed tihs, but nothing would be enabled in there unless certain drivers for the modem was installed.

Best link I've ever found for bonding is

http://www.56k.com/reports/bonding.shtml. That should answer pretty much everything you need to know.

as far sygate goes,you would just configure it to use a dialup connection. If you bond your modems, you should be still only using one DUN connection (the nultilink will take care of the other connection.

Mark

by frank.vrba

Check out an analog router. NetGear, 3COM and others. One of the other answers about the ISP supporting this is necessary, too, as far as I know. These devices are pretty easy to use and configure and can supply Internet access to multiple computers from one dialup connection.

by staci

I'm not sure if this will help, however, there is a software call Spartacom Modem Pooling Software. www.Spartacom.com I use this in our office to let 13 people share four modems. It works great, however, it is around $300 - $600 depending on the version you get. Good luck.

This discussion is closed to new replies.