Discussion Locked

modem prob/cant read port from registry

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I installed a video card in a hp pavillion, (4456)366Mhz now my modem will not work.It gives me an error (cannot read port from registry)NO conflict in device manager.It will install on com2, I don't see a com 3 or 4 available.Did diagnostic, it says cannot communicate w/ modem , make sure its turned on. I'm running ME. Checked bios, only 2 com ports available.Worked fine w/ ME before video card installed.

6 replies

by ann777

Are both the modem and the video card using the same IRQ? Check device manager.

by ann777

There may not be conflicts reported in device manager .... but if they both share the same irq, then I recommend that you move the video adapter to another irq.

IRQ Conflicts with PCI Display Adapters
When you install a Peripheral Component Interconnect (PCI) video adapter that is configured to use a particular interrupt (IRQ), Windows may configure it to use another IRQ that is already in use by another device.

CAUSE
PCI devices can share PCI IRQs, but Windows does not support sharing PCI IRQs with other non-PCI devices (such as an IDE controller).

RESOLUTION
Use Device Manager to resolve the conflict by assigning a different IRQ to one of the conflicting devices.

by jesselou

uninstall your modem completely by going to add remove program and choose remove. go to your control panel and click modem remove the modem over there then check also the device manager if the modem still there choose uninstall. restart your computer and windows will prompt you a dialog box searching for a driver of your pci communication device point to where your modem drivers location and windows will install your modem. when finished go to your control panel select modem thn diagnostics click more info if responded its bingo you configured well.

This discussion is closed to new replies.