16 replies
by lonniec1143 Accepted solution
by slayer_ Accepted solution
Possibly badly seated or broken RAM, CMOS battery could be dead, CMOS jumper could be in the reset position (or may need to be reset)
Try putting the jumper in the reset position, start the system, if it doesn't auto turn back off, wait a moment then turn it off, move the jumper back to the run position and start again.
The jumper is usually right next to the battery.
by lonniec1143 Accepted solution
by robo_dev Accepted solution
Is the PC booting and giving normal bootup beep codes?
Are keyboard lights lighting up, and does the caps lock work?
by lonniec1143 Accepted solution
by robo_dev Accepted solution
by lonniec1143 Accepted solution
by dldorrance Accepted solution
by lonniec1143 Accepted solution
by santeewelding Accepted solution
Is, having tested the original monitor on another system at the outset. Assuming the second, known-good monitor was indeed good, I suppose you accomplished the same thing, and I don't fault you.
I guess the only good thing about this is that you are doing it for a friend, at no charge. If you are charging, you are going behinder the further you get, even at minimum wage.
by seanferd Accepted solution
by r3al1ty Accepted solution
by lonniec1143 Accepted solution
by robo_dev Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending