Discussion Locked

MS-DOS compatibility mode file system

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
My system is running very slowly,going into my system properties performance I find that I had somehow reconfigured my system.How do I find the driver causing my problem? How do I fix this error?? Drives C,D,& E are effected.

13 replies

by okeedoky

I would check your device manager. If your cdrom drive is not listed and your hard disk controllers have an ! on them ... run a virus scan. You could have a virus. Also check your autoexec.bat and config.sys for any real mode drivers that are loading up. You can put an REM in front of each line to see if the issue goes away or simply rename autoexec.bat and config.sys. You can also check your performance tab under your system properties. Go to File System and Troubleshooting and make surenothing is checked here. I hope these items help in your quest for a resolution.

by dmiles

Click on Start>Settings>Control Panel
Double-click the System icon,Select the performance tab,it will show you what drives are running in compatibility mode.
Now go to Microsoft Knowledgebase and locate a solution to solve problem,you can also reference previous questions,by typing ms dos compatibility mode in the box in right corner and clicking on go in TechRepublic
In upper right corner

by dmiles

Click on Start>Settings>Control Panel
Double-click the System icon,Select the performance tab,it will show you what drives are running in compatibility mode.
Now go to Microsoft Knowledgebase and locate a solution to solve problem,you can also reference previous questions,by typing ms dos compatibility mode in the box in right corner and clicking on go in TechRepublic
In upper right corner

by william jay

IDE drives usually get put into dos compatibility mode via config.sys and/or autoexec.bat by loading cd drivers. if you want cd drives in a dos mode session, take the offending lines out of there and put them in %windir%\dosstart.bat.

To give thewin95 a cosmic reset, from Windows Explorer or File Manager -> rename config and autoexec, then run regedit and delete the key HiveKeyLocalMachine\enum, then shut down , hardware reset, boot to Windows, which will enumerate the devices again for thefirst time and detect and install all the new hardware it finds ...

**tip: when the installations are happening, windows may ask several times if you want to restart. Just say no and the installs will continue. After it finishes restart and it may commence again, as the controllers come online and find their children. After going through these routines until finished, check in device manager to see that everything is as expected, then go to control panel, run add new hardware, and see if thesystem finds some more.

by fenaikh

Hi
answer 3 is a good answer to start with.
there are 3 situation where you get this:
please do them as listed.
1- You have a virus clean it.Boot clean then
run a virus cleaner.
2-You ahve "noide =1" on your registry delete the entry.
start->run->regeitCtr+f->type "noide" no qutation->delete the entry.

3- your mother board driver need to be reinstalled.Get the lates driver form your vendor then install it.

good luck.
Mohamed

by j.h.tice

This problem can occur if you are using any third party drive translation software. In this case the 32 bit disk drivers can object to the drive geometry reported by the BIOS and revert to Compatability Mode.

In any case, starting Windows with BOOTLOG will tell you where the error is (F8 at startup)

See this article (largely cribed from the MS KB) for more in depth details.

http://www.wdc.com/service/tip_dir/tip0698.html

This discussion is closed to new replies.