Question Locked

my dell optiplex gx240 blue screen error

0 helpful
19 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello!
after i reformat my hard disk drive (maxtor 40gb) and installed a fresh copy of windows xp service pack 2 then reboot it, suddenly it asked to, safe mode, start windows normally, so on, but however no matter which one i select does blue screen of death having these stop codes 0x0000007b (0xF9E4952B 0XC0000034 0X00000000 0X00000000)ive formatted my hard drive many times and partitioned it well but it still happen my motherboard is foxconn LS-36

i am using bios revision AO3 now, i cant reboot my pc, just the bios??

i dont know what to do now,,, so please help me here ..
thanks

19 replies

by rob miners

Try Booting to the Recovery Console.

Insert your XP CD and when you see ?Press any key to boot from CD? press a key. Now wait for the XP installer to finish loading up and you will be presented with the option to press R to Repair.

Press R.

The next screen will ask you which Windows installation you would like to log on to. Normally the following will be listed:

1: C:\WINDOWS

Press 1, then Enter to continue.

You may now be asked for the Administrator password. If you know this type it and press Enter. If you don't know the Administrators password it may be blank. Just press Enter or type your username and password.

At the command prompt type:

chkdsk /r and press Enter.

You can use the Hard Drive Makers Testing Utility to Test the Drive

Seagate "Seatools"

http://www.seagate.com/support/seatools

Works with Seagate drives only

If the Drive tests out OK and you are still having trouble try this before a Repair Install.

Insert your XP CD and when you see ?Press any key to boot from CD? press a key. Now wait for the XP installer to finish loading up and you will be presented with the option to press R to Repair.

Press R.
The next screen will ask you which Windows? installation you would like to log on to. Normally the following will be listed:
1: C:\WINDOWS

Press 1, then Enter to continue.
You may now be asked for the Administrator password. If you know this type it and press Enter. If you don't know the Administrators password it may be blank. Just press Enter or type your username and password.

At the command prompt type:

fixmbr and press Enter

fixboot and press Enter

Wait until you are returned to the Recovery Console.

Once you are back to the Recovery Console remove the XP CD and restart your PC.

Repair Install

1. Insert the Windows XP CD into your computer's CD drive or DVD drive, and then restart your computer.

2. When the "Press any key to boot from CD" message appears on the screen, press a key to start your computer from the Windows XP CD.

Note Your computer must be configured to start from the CD drive or DVD drive. For more information about how to configure your computer to start from the CD drive or DVD drive, see your computer's documentation or contact your computer manufacturer.

3. You receive the following message on the Welcome to Setup screen that appears:
This portion of the Setup program prepares Microsoft Windows XP to run on your computer:

To setup Windows XP now, press ENTER.
DO Not Press the first R press ENTER.
To repair a Windows XP installation by using Recovery Console, press R.

To quit Setup without installing Windows XP, press F3.

4. Press ENTER to set up Windows XP.

5. On the Windows XP Licensing Agreement screen, press F8 to agree to the license agreement.

6. Make sure that your current installation of Windows XP is selected in the box, and then press R to repair Windows XP.

Note If Windows XP was preinstalled on your computer, and you do not have the Repair option, contact your computer manufacturer to make sure that you have the installation CD for a repair install.

7. Follow the instructions that appear on the screen to reinstall Windows XP. After you repair Windows XP, you may have to reactivate your copy of Windows XP and you will have to apply Service Packs.

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D

by baluyot_gerard

do you think changing my operating system from xp to linux will help???

by rob miners

and you are comfortable making the move to Linux you should be OK. A bit drastic but OK. ;)

by baluyot_gerard

why? because when i tried the hdd drive to other pc.. it worked, i just want to avoid the blue screen so that i can continue working :D thanks

by baluyot_gerard

will it work if i boot the hdd drive in other motherboard?? because dell wont recognize the cd :) i will reinstall the os in other motherboard.. will that work?

by rob miners

isn't your CD Drive recognising the Linux CD. Is it bootable. What happend when you ran the checks that I previously posted.

by baluyot_gerard

you are saying that i must install the os in my dell pc??

my dell dont recognize my cd rom drive.. i mean although my cd rom drive is properly inserted... it says that CD - ROM (not installed) so i try it to other motherboard...
do you think my decision to format my hdd to other motherboard will be the problem

by baluyot_gerard

you are saying that i must install the os in my dell pc??

my dell dont recognize my cd rom drive.. i mean although my cd rom drive is properly inserted... it says that CD - ROM (not installed) so i try it to other motherboard...
do you think my decision to format my hdd to other motherboard will be the problem?

by baluyot_gerard

is to format my hdd drive to other, motherboard because my pc doesnt recognize cd rom drive.. so i installed my os to other motherboard

by baluyot_gerard

i want to install the linux os in other motherboard then install the hard disk in my dell pc will that work?

by dumphrey

you want to install linux onto a HD from a computer we will call ComputerA. You then want to take the hard drive out of ComputerA, and put it in ComputerB. With Linux, this should work as long as computerA and computerB are similar enough. It should also work for XP, as long as you are using a full version install, OEM versions (Dell, Gateway, HP, etc) will refuse to boot on boards not built by their respective vendors, and legally cant be run so anyway. Windows2000 had lots of issues with this, and it was/is usually quicker to reinstall.

What bothers me is that the cdrom in your computer is refusing to read the cds. I would guess it has a bad jumper setting, bad cable, or is just worn out.

by Former member

Why you are getting the blue screen is because the hdd in question has bits of Windows still on it. You will have to give it a good clean out and this little program will do just that.
KillDisk:
http://www.killdisk.com/
Download it and burn to disk.
Load this into your laptop drive and run it, all you need is the one pass method.
When finished you can then load on Windows.
If your Cd/dvd drive is being seen in the bios then it should work ok.

Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.

by baluyot_gerard

can i use that in other pc?? .. i mean i will put my hdd drive to other motherboard will that work??

by Former member

Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.

by dumphrey

when you use killdisk/Dban type disk erasers, its best to not have any disk you want to keep as is connected to the motherboard to prevent accidentaly erasing your partition info (it can happen in seconds).

by baluyot_gerard

my dell pc...doesnt recognize my cd rom drive it says on bios (not installed) all the jumpers are correct and the cable was newly bought

by rob miners

replace the CD/DVD Rom drive in the Dell or slip another one in temporarily to do the reinstall.

Keep us informed as to your progress if you require further assistance.

If you think that any of the posts that have been made by all TR Members, have solved or contributed to solving the problem, please Mark them as Helpful so that others may benefit from the outcome. ;) :D

by 7425kennedy

We have a dilemma, we cannot locate the recovery disks for one of our computers. (By the way, the mouse pad scrolls faster than my fingers and it selected more employees than we have. We are a small start up company with less have 20 employees at the moment.) One CPU is offering this dreaded blue screen error whenever we are booting the system. We are running Windows XP with BIOS A03; the error states MACHINE_CHECK_EXCEPTION. It is advising us to remove any newly installed hardware or software, disable BIOS memory. Technical Information 0x0000009c (0x0000000,0x80$4E1F0,0xA2000000,0x84010400)
I have tried to use F12 to get to the Advance BIOS screen to hit reboot but the system does not offer that option. I am in need of some assistance on rebooting this CPU.

This discussion is closed to new replies.