Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Are there any techs out there that have set up the Netopia R9100 (upgraded from 71xx), to work with the Qwest ADSL service? I know Qwest uses the Cisco 678, which we have running, but we need more capabilities that the Netopia gives us versus the Cisco. I also know that we are on some new Qwest lines running the "DMT" service (fiberoptic I believe).
2 replies
by acattr
You can get documentation on setting up a netopia R9100 ethernet router at www.netopia.com
All you need from Qwest is an IP address to give your R9100's WAN ethernet interface. You give the LAN ethernet interface an IP address and enable Addresstranslation.
To do this:
login to the router
go to easy setup
enable address translation
Input (Qwest's Wan IP and subnet mask)
next screen
Input (LAN IP address and subnet mask)
Input (Qwest's WAP IP Gateway)
everything else is optional
Reboot Device
and have fun.
by mlackner
Thanks for the reply. Unfortunately, it's a bit more complicated. We are on a private IP Address network here, and I tried setting it up with NAT but it still does not work. Anyone running on Qwest with Netopia router, using NAT etc?
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
24 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies