Discussion Locked

Network card not detected at system restart

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Help!

I use ADMtek AN983 10/100 PCI Adapter on Windows XP professional. When I start the machine, it find the card. However, if I need to restart the machine for any reason, the system cannot find the card. I have to turn of the PC, then switch off the power from the mains, then start again. It found the card only in this manner. Am I having a hardware problem or what?

It is plugged into a PCI slot. (Not an on-board adapter.)

3 replies

by ghimpe--

Are you having IRQ conflicts??
Try a different PCI slot. Try (if posible) the NIC in another PC.

Post back with results ;)

by ghimpe--

Are you having IRQ conflicts??
Try a different PCI slot. Try (if posible) the NIC in another PC.

Post back with results ;)

by hal 9000

With some NIC's chip sets they didn't like to play nice particularly if you have more than one fitted. There can be a basic driver conflict between the Chip set on the M'Board and NIC which can cause some problems and there are other times where a problem arises from just placing the NIC into the wrong PCI Slot as the shared IRQ's DMA's or whatever do not work properly with the M'Board. Sometimes just moving the NIC to a different PCI Slot will cure this and sometimes a different chip set NIC will cure the problem.

The first option is always the better and you can move it one PCI Slot at a time until you either have a working stably or you have eliminated every PCI Slot as a possible option. If you reach the latter stage you'll need to try a different chip set Card and that should cure the problem.

Just a note of warning here if you have an On board NIC that is a Gigabit you will be unable to use a 10/100 NIC on the same Board as they conflict, if you have not got a on board NIC forget the last paragraph.

Col

This discussion is closed to new replies.