Discussion Locked

Network card problem

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
when I first install it works fine. after a while it does not see other computers in network neighborhhod. about three months. realtek card nd windows 96 OS using tcp and pntium2.

9 replies

by ann777

How large is your network?

If it is viable, install Microsoft NetBEUI protocol on your server and reboot. In either case, you should not have disappearing computers in network neighborhood if the protocol stack is working properly.

by admin

I assume you are using win95? or 98?
Check the number on your network card chip. If it's an 8029, then the drver for this corrupts. The easiest thing to do is get a new card. Some win drivers say they've fixed this, but I've never seen one work long term.

Hope this helps.

by jwilczyn

1.Check your network cable and the network connector - try to use a different cable and put it into a different wall connector.
2.Change to a different port in your hub.
3.Try to replace this card with the same one (working).
4.Reinstall/update adriver.
5.Check your network setting (for TCP/IP - DHCP- dynamic/static address, DNS and WINS).
If your network is small and you don't need routing - install NetBEUI in your network.

Good luck

by estebandelatorre

Try to upgrade the driver or go back to previous version. Many times, windows SP's update some nnic drivers, any many times they do not work as expected.
The Sp instalation may be the after and before..

Good luck

This discussion is closed to new replies.