Discussion Locked

Network Neighborhood

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Scenario:
There are about a hundred computers in a NT 4.0 Domain. I will use computer A, B, and C as example. A printer is attached to computer C. When I logged onto computer A, I could not see computer C and the attached printer, therefore I can not print to it. However, using the same login name or user ID, I log into computer B, and I can see computer C and the attached printer as well as print to it. Why is that? What do I need to do so computer A can see computer C and print to the printer that is attached to computer C. Does it have to do with some kind of computer profile or user profile or network profile?

9 replies

by abu_danny

Hi,
for your computes to see each others, they must be all in th same Workgroup and on the same Network Mask.
so, A & B & C should all be in the same IP range on the same Subnet mask, and all should be in the same WorkGroup.
I beleive this shouldget you sorted :-)
PS: Don't forget to share your printer 1st before looking for it...

by m.carter

Hi

You need to make sure that all three computers are connected to the same workgroup. Have you checked that the file and print sharing is installed and that it is ticked the TCP/IP properties under bindings. Also you need to double check that the printer is sharing

Hope this helps

Cheers

Martin

by mike o

Can computer B see computer A? Or vice versa? Can they all ping one another? You might also want to doublecheck your hardware and wiring. You mentioned you have a hundred computers, so you've got multiple hubs/ports. Couldn't hurt to make sure one network segment isn't down and/or you've got a bad/misconnected wire.

by jmstitt

Hi, We have about 120 NT4.0 machines. We use roaming profiles. The printers had to be installed on a per user, per computer basis. When a user would move from computer to computer, the printer would have to be installed if they had never logged inat that machine before. After the initial login and install, then the printer would remain and could be shared. But if the user changed, the printer would need to be reinstalled under that users profile. I don't know if this is your problem, but it was the case in ours - THT

This discussion is closed to new replies.