Discussion Locked

Network port change from 10mb to 100mb

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
After upgrading the switch port, that a server is patched into, from 10 mb to 100mb the server doesn't seem to be able to cope with the increase. Is it a simple matter of rebooting the server or does the network card driver need updated. The card is Compaq NC3120 Fast Ethernneet NIC.

9 replies

by leon_guerrero

Did you check the card configuration? Go to your network settings and look at the adapter configuration and make sure its set up for 100mb.

by ntoz

If your settings are for autonegotiation or Full Duplex, change them to 100 and half duplex. Windows NT in mosts cases will not work properly under Full Duplex and AutoNegotiation has always been an issue also.

Pete

by cavedweller

In addition to checking the NIC configuration, make sure you are using CAT-5 or better cables, patch panels, building wiring, etc. Poor cable will cause all sorts of problems.

by nsa13

Marc,

We had that issue come up. I bet if you run perfmon you'll notice a lot of packet errors incoming. Maybe some outgoing. You need to bounce your box (reboot the server) in order for the Compaq FE NIC to reestablish a Full Duplex connection.

I had a Compaq 3000 and 6500 that this very thing happened to. I had them working on a 10baseT hub and then bought a 10/100 Managed Switch. The ports were hard locked at 100 but the NICs were acting really wierd. Rebooted the boxes and they worked like a champ. =)

GL

This discussion is closed to new replies.