Discussion Locked

network start up disk

0 helpful
11 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Trying to create a network client installation start up disk to for a server based installation of WS 4.0. Have copied files from i386 to a folder C:\clients and shared it. When I specify a path in Network Client Installation Files dialogue box I get this error "path specified does not contain network installation files". The path I type is C:\clients. What am I doing wrong? Thanks Michael

11 replies

by msillers

You can either copy the files from the Clients directory on the NT server CD to your shared directory or point to this directory when making the start up disk. You might want to use the cd so as to leave the i386 files intact in your shared clients directory.

by beldin32

You cant use the format c:\clients, you must use the UNC format eg \\SERVERNAME\SHARENAME otherwise it wont work.

by mjkqb

Thanks for the help. I have my start up disk. Now, what is the procedure for booting the remote computer? thanks, Michael

by azizhakim

ok ,you stated you have you start disk ready.
you did it with your dos formatted disk,through network client application made a start disk,assigned ip address either dynamically or static,edited the protocol ini,system ini file to install the drivers you have from your network interface card,you need to to do one more thing.you need to edit your autexec.bat file in your start disk.delete your last 2 lines,add
net use z:\\server name\share name & run winnt/b.On you server,share & map your i386directory to the drive for the client, in our case z:.Hope it helps.I did try & accomplish it,but it did take many tries.I can fill you in a little more@azizhakim@yahoo.com

by azizhakim

A little thought,i made unclear.In you net start disk you are installing the drivers for your nic.If you do have the card that microsoft has the generic drivers eg 3com etherlink,you dont undergo editing the protocol&system files,just edit your autoexec
file like above.Hope this helps

by schitzoid

The path its looking for is not to the i386 directory, it's to the folder named "client" on the server cd, this folder has the msclient for dos needed to make your boot floppy. you use this floppy to boot the new machine and map to the share with the i386 files(I like to copy this folder to the drive of my server so i don't need to mess with the cd). by the way, you will still need to sys the floppy from dos/9X, as the client applet only copies the networking stuff to the floppy.

This discussion is closed to new replies.