Discussion Locked

networking with 1394 network adaptor

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
A sony vaio PCG-SR5K with w2k and a home desktop with windows Me. The Vaio has a 1394 network adaptor, the desktop has a 1394 PCI network adaptor. The Vaio can see the desktop with the smart monitor activated but can't communicate. Things that have been tried. Smart connect switch set to standard, installed netBEUI (can't get a ping) can't install a TCP/IP network protocol except for the internet protocol. tried to specify an address between the 2 pc's, Any ideas?

5 replies

by sleathwood

Are you sure those are network adapters? IEEE 1394 is generally used as a High Speed Serial interface for digital cameras, scanners and external Hard drives. http://www.ti.com/sc/docs/products/msp/intrface/1394/tech.htm . If I misunderstood the interface part of your question, here are some standard networking things to check. Is your Hub showing link lights? If you don't have a hub, are you sure you are using a cross over cable? You will not be able to Ping a thing until you can install TCP/IP, as Ping is a TCP/IP tool.

by gentryc

I also think that the 1394 is not a network adapter. 1394 is a standard for fire-wire products...digital camera, hard-drives, video, etc...

NetBEUI will not be able to ping since that uses ports and tcp/ip is the only protocol that uses ports.
Under the Device Manager, under Network Adapters, does the manager see the 1394 device as a NIC? It should be under its own device..1394?

This discussion is closed to new replies.